Step 8-1
Bend the wire arm rod at a 90° angle as shown. The length of the arm rod above the bend is your choice. Consider the final use of the puppet and what is most comfortable for you personally.

Step 8-2
Cut the wire rod just past the bend. To gauge where to cut the rod, keep in mind that once the rod is inserted into the hole in the handle, it should not extend out of the opposite side. Use the 5-Minute Epoxy to secure the rod to the handle. Allow the epoxy time to fully set.

Step 8-3
Tape the handle for added strength and a better grip surface. We have found gaffers tape to be excellent for the job.

That’s it! You’ve just added permanent arm rods and posable hands to your puppet character!